Phatronics Heater Analog Mixbus Enhancer Harmonic Coloration Saturation and Glue for your mix!

$249.00

Category:

Description

Grab it while it’s hot!

The Heater. ©™ Analog Mixbus Enhancer. Patent Pending.

This has been an idea that has been floating around our heads for some time. Yes, there are many great plugins available that emulate analog sound. There is also some great hardware that you can run your mix bus through to make your sound warmer and fatter. Problem with the hardware is, those type of boxes cost $3000.00 and up. They are out of reach for many of us.

Phatronics has figured out a way to make a box that sounds great, gives you that large format recording console sound, and it won’t break the bank.

Introducing The Heater. The hand made, point to point hand wired box that runs your mix bus (or any source you want) through 600 ohm 1:1, isolated audio transformers. Now your DAW mix can REALLY sound like it is going through the center section of a vintage console.

 

A transformer is a component that transfers electrical energy from one circuit to another via inductively coupled conductors — coils of insulated wire wound (most often) around a ferromagnetic core. Transformers are useful in audio recording, as they can block DC voltage and facilitate electrical isolation between gear, but they also shape the sound of signals sent through them by introducing subtle, often very desirable “coloration.” This may be a result of any combination of frequency response, time response, distortion or a number other factors. These effects can be especially attractive when working in the digital realm, where sounds can be perceived as too “cold” or “digital.”

The louder signals are applied to a transformer, the core saturates and clipping occurs. This distortion creates more low-frequency harmonics than high-frequency harmonics, leading to a warm, dense sound. Even at lower than clipping levels, the magnetic properties of the core change slowly, due to hysteresis7, which also leads to extra low-frequency harmonic content. Our transformer design provides its own unique flavor of harmonic coloration.

Somewhat like compression, a near-saturated transformer gives a mix some glue and air, an indescribable filling in of sonic gaps for a more cohesive sound with more character and density. I sometimes run mixes through transformers at unity with no increase in level or saturation just for some of that analog glue.

Features:

  • Original Custom Designed Circuit
  • Completely Hand Made
  • Hand Wired, Point To Point
  • Custom 3D Printed Case
  • Phatronics Custom 600 Ohm 1:1 Audio Transformers
  • Stereo analog meters with driver board
  • Stereo XLR In / Out
  • Warm, Fat, Harmonic Coloration (The more you drive it, the more saturation)
  • All top of the line electronic components
  • Completely tested on the bench and in the studio
  • Meter Calibration pots inside if need to adjust
  • Electronic relays with flyback circuit
  • Tested 50hz to 10k with no signal loss
  • Comes with 9V Adapter